layer of oxide
英 [ˈleɪə(r) ɒv ˈɒksaɪd]
美 [ler əv ˈɑːksaɪd]
氧化层
双语例句
- A fine layer of oxide on the surface of a metal.
金属表面的一种良好的氧化层。 - This variation becomes unavoidable and serious in the deep submicron era due thickness, dishing and erosion effect on copper metal layer, to limited lithographic resolution, a variety of oxide so on.
这种变异无法避免而且在深亚微米领域，受限于光刻分辨率；氧化层腐蚀造成厚度的改变，因化学机械抛光铜金属线使铜金属层所造成的不平坦碟型缺陷等种种因素变得更加严重。 - Determination of Mono layer Structure of Vanadium Oxide Supported on Titania Catalyst by Thermal Analysis
热分析法钒钛负载型催化剂单分子层结构的测定 - But there is a layer of oxide film on their surface that leads to solder difficult, which holds back its application gravely.
但是由于其表面有一层致密而稳定的氧化膜，软钎焊接性能很差，严重阻碍了它的应用。 - Air plasma spray technique was used to gain a thin and porous anode layer of intermediate temperature solid oxide fuel cell SOFC by taking charcoal active powder as pore-forming agent in this paper.
采用大气等离子喷涂技术，以活性炭粉作为成孔材料，获得了薄且多孔的中温固体氧化物燃料电池SOFC阳极层。 - Preparation and Characterization of TaN ALD Precursors Atomic layer deposition of metal oxide films
TaN薄膜原子层淀积（英文）原子层淀积制备金属氧化物薄膜研究进展 - Tungsten STM tips made by electrochemical etching are always covered with a layer of oxide film, which greatly affects the quality of STM images.
电化学腐蚀得到的扫描隧道显微镜（STM）钨针尖表面通常覆盖了一层钨的氧化膜，这层氧化膜的存在很大程度上影响了STM扫描图像质量。 - Marker technique is used to identify the mechanism of oxidation. RBS measurements are used to study the thickness of transition layer and composition of the oxide.
本文用Marker技术证实了这种膜的氧化机制，并用RBS测量研究了过渡层厚度和膜的成分。 - SUPER-THIN LAYER ELECTROFOCUSING Research on TDDB of thin gate oxide
超薄平板等电聚焦电泳薄栅氧化层的TDDB研究 - The outer layer of the oxide film consists of TiO 2, TiO and a little Ni; the relative contents of TiO and TiO 2 are 30.32% and 69.68%, respectively;
氧化膜的最外层由TiO2和TiO及少量的Ni组成，TiO和TiO2的相对含量分别为30.32%，69.68%； - Compared with the oxide layer of the vacuum-annealed sample, the oxide layer of the air-annealed sample has a more complicated microstructure, and poor bonding strength with the substrate.
与真空炉试样相比，空气炉中生成的氧化层结构更加复杂，与基体的结合强度低； - The basic principle is introduced for protecting metal materials from being carburized by employing surface treatment technology according to the specific carburization corrosion in industry, which forms a dense and continuous layer of oxide with high stability.
根据工程实际中存在的渗碳腐蚀状况，阐明采用表面处理技术防止金属材料产生渗碳腐蚀的基本思路是在预防护工件表面形成具有高稳定性的致密、连续的氧化物。 - The surface layer consists of oxide, sulphide and N, C compound.
表层由氧化物、硫化物和氮（碳）化合物组成； - During the wear process, the sulphide layer could promote the formation of oxide on the rubbing surface.
在磨损过程中，渗硫层促进了摩擦表面氧化物的形成。 - Moreover, sheet billet containing Cu, Ni will bring about a layer of viscous iron oxide scale when heated in soaking furnace that resulted in influence on the surface quality of steel product.
此外，含Ni、Cu合金元素板坯在均热炉内加热时会产生很粘的氧化铁皮，影响钢材表面质量。 - Thus the Cr-O-N layers can act as active diffusion barrier. The O and N compositions in the Cr-O-N layer affect the continuity and density of the Al-rich oxide layers, and influence the inhibition effect of the diffusion barriers accordingly.
Cr-O-N层中O和N含量影响生成富Al氧化物层的连续性和致密性，从而影响其阻挡元素互扩散的性能。 - Experimental results indicate that the first step in the whisker growth is the nucleation of the vaporized nuclei on the oxidized surface layer of aluminum powder particles or the surface of aluminum oxide substrates.
实验结果表明，该晶须的生长首先经过气态成核粒子在铝粉颗粒表面氧化层上或氧化铝基质表面成核，晶核可能以无定形、多晶或单晶的形式存在。 - On the outer layer of oxide film ( Fe, Mn) Cr2O4 is main component and fills the role of wettability with glass.
氧化膜表面为（Fe，Mn）Cr2O4，主要起浸润玻璃作用； - During annealing process, the substrate is also oxidized, which induces a thin layer of silicon oxide existing at the interface of ZnO/ SiC.
在氧气氛中退火时，衬底也会轻度氧化，从而导致在ZnO/SiC界面处存在一层很薄的Si的氧化层。 - Bulk construction in the SiC fibre may be ultra-fine crystallite of β SiC; on its surface there is a layer of silicon oxide, which may be α SiO_2 crystallite.
其体相结构为超细的βSiC微晶结构，其表面存在硅氧化合物层，可能为αSiO2结构。 - It is shown that a thin layer of oxide film is formed on surfaces of TiN films anodized in dilute phosphoric acid solution.
结果表明，在稀磷酸溶液中对TiN薄膜进行阳极氧化处理后，在TiN表面形成一层氧化膜。 - Atomic layer deposition of metal oxide films
原子层淀积制备金属氧化物薄膜研究进展 - A dense layer of oxide film was formed on the material surface after anodic oxidation, to some extent, this layers improve the corrosion resistance of aluminum and its alloys.
经过阳极氧化后的铝及其合金材料表面生成了一层致密的氧化膜，能够在一定程度上提高铝及其合金的耐蚀性能。 - We find that the spin-coated seed layer as the growth units of zinc oxide nanorods directly leads the zinc oxide to grow along the ( 002) crystal plane; precursor solution concentration and growth time exert great influence on crystallinity and photoluminescent properties.
我们发现，旋涂种子层作为氧化锌纳米棒的生长基元，直接决定了氧化锌沿（002）晶面取向性生长；前躯体溶液浓度和生长时间对其结晶度和发光特性有影响。 - Alternating with silica sol and ethyl silicate binder as the binder using on the back layer of zirconium oxide ceramic can improve the mould strength, while providing a good deformability of the mould.
采用硅溶胶和硅酸乙酯交替作为背层粘结剂可以改善氧化锆陶瓷型壳的强度，同时能够具有良好的退让性。 - Fabrication of multifarious patterned ZnO nanowires array structures using surface patterning and low-temperature hydrothermal methods. First, seed layer of zinc oxide substrate was sputtered on the Si substrate by ion beam sputtering with the different substrate temperature.
利用图案化种子层和低温水热法制备多种图案化纳米线阵列结构。首先利用离子束溅射技术在基底上溅射氧化锌种子层，研究了不同基底温度对氧化锌纳米棒形貌的影响。 - The electron mediator, o-phenylenediamine ( OPD), was also co-immobilized with HRP in the inner layer on the surface of an indium tin oxide ( ITO) electrode.
将电子媒介物邻苯二胺和HRP共同固定于掺铟氧化锡（ITO）电极内层。 - However, a layer of inert thin oxide film is easily formed on the aluminum surface and prevents water from contacting with Al metal surface.
但是铝表面易形成致密的惰性氧化膜，导致其在水中几乎不反应。 - The laboratory is used in atomic layer deposition method, so the paper firstly studies the different growth temperature, atomic layer deposition process of zinc oxide thin film growth rate.
由于实验室采用的是原子层淀积方法，所以论文首先研究不同生长温度条件下，原子层淀积工艺对氧化锌薄膜生长速率的影响。 - The methods of chemical dipping widening pore and electrochemical thinning were used to treat the porous layer and barrier layer, respectively. The effects of the structure of porous layer and barrier layer of pre-existed oxide film on the subsequent anodization of aluminum in oxalic acid were investigated.
采用化学浸渍扩孔、电化学减薄这两种方法分别处理预氧化膜的多孔层和阻挡层，探讨了预氧化膜结构对后续氧化的影响。